The Dome Mouser is totally integrated with Vera, getting set up is super easy:
Initial Setup
Pairing
1. Under 'Devices' select 'Add Device'
2. Under 'Other Devices' select the 'Dome Smart Electronic Mouse Trap' and follow the prompts
3. Your Mouser is ready to rock
Interface
Once your Mouser is installed, you can access it under Devices
Click on the arrow button on the Mouser to open up the device menu
If you would like to change the settings on your Mouser, you simply click on Device Options
Under Device Options you can change the settings as follows:
NOTE: All options listed below are 1 byte hex except parameter 3 which is 2 byte hex
1: This parameter sets the value sent by the BASIC_SET command to Association Group 2 (for more information, see “Assocation Groups”.)
01 BASIC_SET Level 00 (0/Turn Off Device)
01 ~ 63 (0 ~ 99)
FF (-1/Turn On Device) FF
(-1/Turn On Device)
2: This parameter sets “firing mode” of the Mouser. Two firing modes are available: in the first (Continuous Fire,) electricity is passed continuously for the entire duration, and in the second (Burst Fire,) electricity is passed continuously only for the first minute and it is pulsed at approximately 400 beats per minute for the remainder of the time.
01 (Continuous Fire)
02 (Burst Fire)
3: This parameter defines how long the Mouser will fire continuously before it starts to burst-fire (see parameter 2.)
64~01 68 (100~360 in Seconds)
4: This parameter enables or disables the indicator LED alarm when the trap is tripped.
00 (LED Alarm Disabled)
01 (LED Alarm Enabled)
5: This parameter sets the amount of time the LED Indicator blinks after the trap is tripped.
00 (LED Alarm Blinks Until Trap is Cleared)
01~FF (1~255 in Hours)
Comments
0 comments
Please sign in to leave a comment.